Type Holders

This holder supports types with any number of digits. The types are supported on the side with a clamping screw. The holder has a mounting pin and can therefore be attached in any press. It is also possible to screw in an impact head, which enables manual embossing.

With this holder, it is possible to typeset two lines above each other. The types are held by line plates and can be tightened with two screws. The holder comes with a mounting pin. Equipment with a manual impact head or a dovetail is also possible.

Type holder for any number of types in several lines. Here, the types are also supported by line plates and screwed tight from the front. In order to enable the easier exchange of the types, it is advisable to order the holder with a dovetail receiver. With this receiver, the mounting pin always stays in the press, but the holder can be pulled out easier.

These type holders are applied in roller presses. The number of digits and the font height can be freely selected. Besides our standard holder, we also construct any other type holder according to your drawings.

Embossing types no. 232 a, without support slot, are inserted into single-line type holders 230 a and in manual impact stamps no. 234. Embossing types no. 232 b, with support slot, are inserted into multi-line type holders no. 230 b and 230 c.

Type holders in connection with embossing types are mainly used to emboss unvarying texts, letter or number combinations in type plates. Their application pays off as of quantities of 40, but is not recommended for smaller quantities, as the exchange of the embossing types takes more time than the embossing of the texts.

All untempered materials like steels, light metal, plastic, leather and cardboard can be embossed. All type holders are also available with a heater.Type holders are delivered in standard designs, upon request also according to your drawings and in any size.

They are applied in any normal embossing press, in roller embossing presses, packaging presses, lable embossing presses and numbering embossing presses with prefixed type holder.

As of a number height of 6 mm, these types have a slot for support with pins.